CHARGER AND REGENERATOR OF TRADITIONAL LEAD/GEL ACID BATTERIES Allows you to charge 1 battery up to 30 ah at a time Includes: cable and pliers Charging cycles - regeneration in 8 cycles: 1 CYCLE: initial test: performs an initial test of the condition of the battery and determines, automatically, what is the next cycle to which the battery should be subjected 2 CYCLE: In this phase, the charger/regenerator desulphates the battery through a high-frequency process (pulse desulphation). G The current and voltage pulses remove the sulphates from the lead plates of the battery, restoring their capacity 3 CYCLE: start-up - initialization of charging mode of starting the charging cycle. Check if the battery can accept charging. This step prevents the recharging of a defective battery 4 CYCLE: This cycle recharges with the maximum current up to 80% of the battery's capacity. Charging is carried out at maximum current, in order to reduce battery charging time and save energy 5 CYCLE: absorption charging (final charge) recharges, with decreasing current, up to 100% of the battery capacity. This cycle is the final part of charging. During this phase the charging current gradually decreases, to prevent the voltage from becoming too high 6 CYCLE: Battery analysis This cycle tests the battery to make sure it is fully charged 7 CYCLE: Float type float charge for maximum performance 8 CYCLE: For maximum battery life, when the battery is not in use, it can be left connected to the charger. The charger measures the battery voltage constantly to determine whether a charging pulse should be initiated. In this cycle the charging capacity varies between 95% and 100%. CODE: 54.100.0097 ORIGINAL CODE: CZ